36-72V DC Input Bldc Motor Driver For NEMA23 BLDC Motor Speed Control

Product Specification

BLDC Motor Driver 36-72V DC Input for NEMA23 BLDC Motor Speed Control

BLDC Motor Driver Major Parameters

Model No. JYQD-V6.5E

Power Input:36-72VDC

Rated power:350W

Suitability :Sensorlesss motor

Max power:500W

Max curernt: 15A

---------------------------------------------------------------------------

Protection: Over-current, short circuit, over voltage, under voltage, locked rotor, over-heating

Control algorithms: Square wave

Dimensions:63mmx36.5mmx33mm

Speed Control:PWM/0-5V

Speed feedback signal output:Yes

Working temp:-20℃—85℃

BLDC Motor Driver’s Advantage

JYQD-V6.5E BLDC motor driver board is a direct current brushless driver board. It is designed to control DC brushless motors and provide precise speed regulation range from 0 to 100%. The control algorithms of this product are based on square wave which promotes its stability and accuracy. This driver board is suitable for a wide range of applications, such as robot, electric bicycle, electric wheelchair, electric scooter and hub motor. The maximum current of this DC brushless driver board is 15A and it is the ideal choice for those who needs a reliable and efficient motor driver board.

BLDC Motor Driver’s Application

Electric skateboard

Electric scooter

Electric wheelchair

Hoverboard

Electric unicycle

Electric Moped

Electric go kart

RC car

Industrial robot

Logistics conveyor belt

Automation equipment

CNC machines

Self-propelled lawn mowers

Application Guidelines

1. Confirm that the voltage and power parameters of the motor not exceed the range as specified.

2. JYQD-V6.5E is driver board without housing and heatsink, it can drive the motor below 100 watt without any heatsink, but needs normal ventilation.

3. The 5V output port on the drive board is forbidden to connect external power equipment. It is only applicable to external potentiometer or switch for speed adjustment, commutation and enabling operation

BLDC Motor Driver’s Wiring

1. Control port

5V —Driver board internal output voltage, external potentiometer or switch for speed adjustment and reversing

operation

Z/F —Rotating direction control ports. Connect “5V” high level or no connect is Forward direction, connect 0 V low level or

connect to GND is reverse direction.

VR —Speed control port. Analog voltage linear speed regulation 0.1v -5V, The input resistance is 20K Ohm ,connect with GND when input PWM speed regulation, PWM frequency:1K-20KHZ; Duty cycle 0-100%,PWM amplitude:5V

Signal— Speed pulse signal output,5V pulse signal

GND—Used for Driver board internal control

2. Power port

MA ----motor phase A

MB ---- motor phase B

MC---- motor phase C

GND ----DC-

VCC----DC +

4. Use shielded wires if the drivers board has more than 50 cm distance from the motor, otherwise it may lead to abnormal driving, affecting the normal use

5. Control port distance: 2.54mm,Power port distance:3.96 mm

6. Pay attention to the insulation between the driver MOSFET and the heatsink or the installation plate.

BLDC Motor Driver’s Dimensional Drawing