Ge Fanuc IC660EBA026 ， Genius I/O Electronic Assembly ， 18-56V DC

Product Specification

Ge Fanuc IC660EBA026 , Genius I/O Electronic Assembly , 18-56V DC

Technical Information

The GE Fanuc IC660EBA026 Genius I/O Electronic Assembly is an input block assembly that is designed to interface analog input devices to the Genius I/O bus. The IC660EBA026 electronics assembly and a terminal assembly make up the complete Genius block. The terminal assembly provides a terminal base for field-wiring and connecting handheld monitors. The terminal assembly also stores all the block configuration in the EEPROM within the terminal assembly. The IC660EBA026 electronic assembly houses the block’s microprocessor and performs all the block’s functions, diagnostics, computation, data storage, and communications. The IC660EBA026 electronic assembly comes with an open type enclosure that supports enclosure installation. It also has a terminal assembly that helps to reduce wiring time, and the electronic assembly can be removed/replaced without removing or reconfiguring field-side wiring.

The IC660EBA026 electronic assembly’s input block interfaces controllers with field devices that provide 4 milliamps to 20 milliamps analog signals. The block is rated at 24/48 Volts DC and it comes with 6 input channels that are individually isolated. Each input circuit is capable of accepting 4 to 20 milliamps rated signals and each can provide up to 24 Volts DC of loop power supply. Each circuit also supports independent linear scaling selection, which can be used to conveniently convert signal values to engineering units that are supported by the application. The IC660EBA026 electronic assembly has built-in diagnostics that perform advanced diagnostics features like low and high alarm reporting, over-range and under-range detection, open-wire detection, and internal fault reporting. The IC660EBA026 electronic assembly is backwards-compatible with previous versions, and it supports only Phase B hand-held monitors (like the IC66HHM501H monitor, version 4.5 or later) for configuration.

About IC660EBA026

The IC660EBA026 input block is a current source input block with an electronics assembly. This input block has been designed and manufactured by GE Fanuc Automation. The electronic assembly for this input block includes all the components that are necessary for the correct functioning of the block, including all the electronics and other components that contribute to the transmission of signals. This input block has an approximate height of 22.44 centimeters, a width of 8.89 centimeters, and a depth of 10 centimeters along. It has a weight of 1.8 kilograms. The GE Fanuc Automation IC660EBA026 current source input block with an electronics assembly has a heat dissipation rating of 12 Watts maximum and it includes 8 switches, 1 of which can perform the BSM controls.

The GE Fanuc Automation IC660EBA026 current source input block with an electronics assembly features a block-to-block isolation rating of 1500 Volts for 1 minute and a group-to-group isolation rating of 1500 Volts RMS. This electronics assembly supports a current source input block voltage of 24 to 48 Volts DC approximately. It supports a power supply voltage of 18 to 56 Volts DC and a maximum current of 700 milliamps. The GE Fanuc Automation IC660EBA026 current source input block has an input impedance rating of 100 Ohms, an open-circuit voltage rating of 24 Volts DC, and a short circuit current rating below 75 milliamps. The assembly has a thermal drift that goes from 25 degrees Celsius and to operate properly, it will need to be attached to a terminal block assembly so that all the block components are complete.

Technical Specifications for IC660EBA026