3.5 Inch TFT LCD Touch Screen with Mipi 2lane Interface and 480x640 Resolution

Product Specification

3.5 Inch TFT LCD Touch Screen  Full Viewing Angle Mipi 2lane With CTP

Product Details

Product Description

Core parameters and features

Size / Resolution: 3.5 inches, common resolutions are 320×480 or 640×480 (varies by model), with moderate pixel density, clear text/icon display.
Display technology: Usually IPS full-viewing angle, with an angle range of approximately 178°, good color and contrast performance, no obvious color deviation when viewed from the side.
Interfaces: MIPI DSI 2-lane, low power consumption, high speed rate, strong anti-interference ability, easy to connect directly with the main control chip, reducing wiring and EMI.
Touchscreen: Capacitive (CTP), supports multi-touch (such as 5 points / 10 points), sensitive response, supports gesture operations; CTP usually communicates with the main control through I²C interface, facilitating integration and calibration.
Brightness / Contrast: Common brightness is 300-500 nits, some high-brightness models can reach above 700 nits, suitable for indoor and semi-outdoor use; typical contrast value is about 700:1-1000:1.
Operating temperature: Industrial grade is usually -20℃ to +70℃, storage temperature -30℃ to +80℃, suitable for most industrial and vehicle environments.
Form and installation: Module thickness is usually around 3.9-4.6 mm, paired with FPC/FFC flexible ribbon cables, facilitating compact installation.

Typical application

Embedded devices: such as handheld terminals, industrial controllers, instruments and meters, smart home panels, etc.
Vehicle HMI: vehicle central control, air conditioning control, vehicle camera display, etc.
Consumer electronics: portable medical devices, handheld game consoles, smart doorbells, etc.

FAQ:

1. I want the LCD display 8 digits and the outline size is 65x30x2.8mm………?

Answer: No problem. Firstly, please kindly send us your specification/ drawing paper 

If you have not the specification, you can also provide your samples; we will recommend the suitable one

 if it is standard products. Or we can customize for you based on your own requirement.

2.This LCD  is just what we want, but it is big size, do you have any smaller size? And the display content need to be changed a little.
      Answer: For the segment type LCD module, if you need modify the outline size or display content,

a new LCD glass module is need. We have to open new tooling for you.

3. This LCD display is HTN type, but I want STN type,can you make?
      Answer: That’s all right .  we can change for you as per you request.

4. I want customize a new LCD module. Can you do?
      Answer: Yes, we can. Please send your drawing paper. If you have not, please advise me the outline size  

of the LCD display, display information( Glass thickness, Polarizer, Display Type, Connector mode, 
Storage Temp. Operating Temp.  Supply Voltage, Viewing direction, drive condition), we can customize for you.

5. What is leading time for tooling?
      Answer: General speaking, it will cost 15 to 25 days  after drawing paper confirmation and tooling charge payment,

we can report you the exact time when you confirm the drawing paper.

6. Can you send us samples for checking?
     Answer: Yes,. Samples order is available.

7. What is the Leading Time?
    Answer: If we have stock for the standard ones, the leading time is one day after payment. If it is the mass production for 

special ones, the leading time is about 15-30 days. suppose we can finish earlier,  we will report the information in advanced.