Ceiling Light Long Strip Microwave AC ON/OFF Motion Sensor, Compatible Working

Product Specification

【Product Feature】

• Patented Mini Coupling DiPole Antenna for ceiling light.
• suitable to built-in metal LED tray without false trigger.
• Compact size, not effect light distribution.
• Low sidelobe, no false trigger in metal reflection space.
• Low transmitting power, no harm to human.
• Sensor data can be set by DIP switch & remote control.
• Not affected by temperature, humidity, noise, dust etc.

【Parameter】

【Function】

【Product Information】

• Dimension diagram

​

Wiring and Function diagram

*The sensor is designed for connect one load only. Connect more than one loads may damage the sensor.

【Installation Instruction】Recommended for use on ceiling lights

• Screw installation

• Snap-in installation

Note: Please check the sensor installation method with Merrytek before design any luminaire.

• Cut size

【DIP Switch Setting】

【Initialization】

After power on, the sensor automatically turns on light to 100% brightness and turns off light in 10 seconds. During initialization, sensor is not able to detect movement.

【Default setting】

Sensitivity: 100%, Hold time: 5s, Daylight sensor: Disable

【Application Notice】

• Sensor should be installed by a professional electrician. Please turn off power before installing, wiring, or setting the DIP switches.
• Microwaves cannot penetrate metal. Do not place product in a closed or a half-closed metal lamp. Neither metal nor glass is not allowed to cover above the product. If antenna needs to pass through the metal plate, please ensure that the top of sensor is close to the metal plate.
• Sensitivity area is related to moving speed of objects, size of moving objects, mounting height, mounting angle, working environment, reflecting materials and etc.. Given detecting area is typical value that was measured by 165cm high testers in an indoor open environment.
• The daylight thresholds are measured on a sunny day without shadow and in an ambient light diffuse reflection status. Different environment and climate cause different brightness values that daylight sensor measures.
• The installation spacing between sensors is recommended to be greater than 2m, and the installation spacing between sensors and routers is recommended to be greater than 2m.
• Sensor should not be covered or hided by metal, PCB, LED tray etc..The spacing between the sensor antenna and surrounding materials should be greater than 5mm. There should be no metal or PCB tracks near the sensor antenna, above or below it. The recommended thickness of cover is 2mm, and keep the spacing between the sensor antenna and cover is greater than 3.2mm.
• Vibration signals will be regarded as moving signals to trigger sensor. Installing sensor should be away from the object that vibrates for a long time, such as large metal equipment, pipes, air conditioning outlets, exhaust vents, smoke exhaust machine ports, shaking fans, etc. Pets in detecting area may cause false trigger.
• The antenna surface of microwave module should be away from input AC, output DC, rectifier bridge, transformer, switch tube and other high-power devices to avoid high frequency signals affecting the normal operation of microwave sensor’s antenna.
• Sensor is for indoor use only. The waterproof effect for outdoor or half-outdoor use will be affected. Wind, rain, and moving objects may cause false triggering.