Table servo hot press

1. Safety warnings and symbols
2. Equipment Overview
3. Technical parameters
4. Installation and debugging
5. Operation Process
6. Temperature/pressure settings
7. maintenance
8. troubleshooting
9. Appendix (electrical diagram, parts list)

1. high temperature scald: the working temperature of the hot pressing plate can reach more than 200 °C. wear thermal insulation gloves when operating.
2. high pressure risk * * : do not adjust the mold or clean the foreign body when the equipment is pressurized.
3. emergency stop button * * : press immediately when the device is abnormal (red button on the right side of the control panel) .

��

• * ▲▼ temperature/pressure control buttons
• * : emergency stop
• * ��: Heat Indicator

2.1 uses: for hot-pressing forming, laminating or edge sealing of plastic sheets, composite materials, films and other materials.

• driven by servo motor, pressure control accuracy ± 1% .
• dual temperature zone PID temperature control (upper/lower hot platen independent temperature control) .
• the touch screen sets the parameters of pressure, temperature and holding time in three stages.

1. Place the equipment on a horizontal surface with ≥30 cm of room for heat dissipation.
2. Connect power supply (3-phase 5-wire ground) to cooling water pipe (if equipped with water cooling system) .

• turn off the power and align the mold with the locating pins.
• bolt the upper and lower dies to ensure parallelism ≤0.05 mm.

1. After power-on, enter the“System self-test" to check whether the temperature sensor and pressure sensor are normal.
2. Set the temperature curve on the touch screen (e.g. , 5 °C/min) .
3. No-load trial operation: Test the mold opening and closing action in manual mode, and confirm no clamping stagnation.

1. Preheating:
   • set the target temperature (e.g. 180 °C) , click“Hot start", and continue after the temperature indicator is always on.
2. Loading:
   • lay the material flat into the lower die to avoid overlap.
3. Initiate lamination:
   • select the preset procedure (or manually enter the pressure and holding time) and press“Auto run".

- after the buzzer finishes, remove the workpiece with thermal gloves.

1. Turn off the heat until the temperature drops below 60 °C.
2. Use special tools to remove the mold and clean up the residue.
3. The pressure zero must be recalibrated after the new die is installed (see section 6.2) .

• go to the“Temperature setting" screen and set:
• upper/lower panel independent temperature
• temperature rise overshoot protection (recommended ≤10 °C)

1. Enter the“Pressure calibration" menu under no-load condition.
2. Slowly pressurize to full scale as indicated and the system will automatically record zero.

Electrical schematic diagram (see Annex A)

Mold installation diagram (see Annex B)

Recommended supplies:

• Thermal gloves (300 °C)
• Release agent type:

Manufacturer: Dongguan Zhengyu Technology Co. , Ltd.

Technical support TEL: 13113126980

1. Appearance drawing/construction drawing of the equipment (indicating the name of each part) .

2. Screen shots of a specific PLC or touchscreen interface (e.g. preferences page) .

3. Table of material suitability (recommended temperature and pressure for materials such as PP/ABS/PET) .