Mindray BeneHeart D6 Defibrillator Power Supply Board 0651-20-76950 Mindray

Product Specification

Mindray BeneHeart D6 Defibrillator Power Supply Board 0651-20-76950

Brief Introduction

The defibrillator power board is an electronic device that provides power to the entire defibrillator instrument. The function of the power board is to supply power to the main control part, measurement part and recording part of the entire machine. The power board converts alternating current into appropriate direct current for transmission. to other boards.

Feature

The defibrillator power board needs to input different power voltages to the module boards in each defibrillator instrument to ensure that other parts can operate normally. Its main function is to convert the input power into what is needed for other electronic devices of the monitor. Stable DC power supply to provide normal power supply for the monitor. Its working principle is to convert alternating current into direct current, and maintain the output current and voltage within a certain range to ensure the reliability and stability of the defibrillator equipment. The defibrillator power strip is also a transformer in the defibrillator machine. When AC power is input to the power strip, the input voltage will be converted into low-voltage AC power in a certain proportion. After the rectification process by the rectifier, DC electricity is generated, and then filtered by the capacitor to eliminate residual clutter, allowing the defibrillator to obtain a more stable DC output voltage. In addition, the power board also contains protection mechanisms, including overcurrent protection, overvoltage protection and overheating protection, to ensure that the defibrillator will not be damaged during use. The feedback circuit can monitor the output current and voltage, and then adjust the rectifier circuit and voltage stabilizing circuit to ensure the stability of the output voltage and current. If the power board encounters liquid, the power board may be damaged at least, or it may affect the function of the entire machine in serious cases. Therefore, if liquid accidentally enters the inside of the machine, please disconnect the power supply immediately and perform maintenance on the device.

Cleaning Instructions: Turn off power to the device, disconnect power from the device, remove all cables and batteries (if applicable) and close the battery door, moisten a soft, lint-free cloth with an approved cleaner or disinfectant, wring the cloth Remove excess liquid and wipe down exterior surfaces. Any contact of the disinfectant solution with metal parts may cause corrosion. Do not damage or bend connector pins when cleaning or drying. Let the solution sit on the device for a while and do not allow the connecting pins to There is liquid accumulation around. If this happens, blot it with cotton or a soft cloth, wipe it clean with a clean, slightly damp cloth, dry it thoroughly with a dry, lint-free cloth, and let it air dry for at least 30 minutes.

Parameters

Product Details Picture

Thank you for taking the time to pay attention to our product Mindray BeneHeart D6 Defibrillator Power Supply Board 0651-20-76950.