ARC Mate 100iD 10kg Payload 1441mm Reach ±0.02mm Cable Integrated Welding Robot

Product Specification

ARC Mate 100iD Cable Integrated Arc Welding Robot

The FANUC ARC Mate 100iD is a six-axis arc welding robot built around a fully cable-integrated design that simplifies welding cell setup. Welding cable utilities run backside the wire feeder inside an enlarged J1 hollow tube, and a unique gear drive mechanism keeps the arm slim even with the torch cable routed through it. With a 10 kg payload and a 1,441 mm reach, this welding robot covers the working range needed for steel and aluminum fabrications while keeping the torch close to the joint for consistent beads and less rework.

Dress-out is a defining strength of the ARC Mate 100iD. Not only the torch cable but also the sensor cable can be integrated through the enlarged J4 and J6 hollow tubes, and the wire feeder mounts compactly on the back of the J3 arm, which reduces cable snagging and extends cable life. Higher arm rigidity delivers high speed and high accuracy, so the welding robot can raise productivity without sacrificing weld quality. FANUC ROBOGUIDE offline teaching shortens touch-up cost, while +RVision integrated vision and coordinated motion with a positioner extend the workstation to more demanding joints.

Technical Parameters

Key Advantages

• Cable-integrated dress-out: torch and sensor cables route inside the arm for a clean, snag-free welding workstation.
• Slim torch-cable arm: a unique gear drive mechanism keeps the arm narrow for better joint access.
• High rigidity: the stiff arm structure supports high speed and high accuracy welding motion.
• Easy system setup: welding utilities behind the wire feeder fit the enlarged J1 hollow tube.
• Lower touch-up cost: ROBOGUIDE offline teaching reduces programming and rework time.
• Smart welding functions: +RVision and positioner coordinated motion extend the range of weldable joints.

Application Fields

• Stainless steel part welding in a welding workstation
• Automotive part welding and body-in-white cells
• Aluminum and general fabrication arc welding
• Multi-pass welding with positioner coordination
• Flexible welding cells using offline programming

Frequently Asked Questions

Q: What payload and reach does the ARC Mate 100iD welding robot offer?
A: The robot provides a 10 kg payload with a 1,441 mm reach, a combination suited to arc welding where the torch, sensor and wire feeder must be carried with a compact, slim arm.

Q: How is the torch cable managed?
A: Welding cable utilities run backside the wire feeder and are integrated inside the enlarged J1 hollow tube, while the sensor cable routes through the enlarged J4 and J6 hollow tubes for a clean dress-out.

Q: How accurate is the welding robot?
A: Repeatability is ±0.02 mm, and the higher rigidity arm delivers high speed and high accuracy motion that improves weld consistency and productivity.

Q: Can the cell be programmed offline?
A: Yes. FANUC ROBOGUIDE offline teaching reduces touch-up cost, and intelligent functions such as +RVision and coordinated motion with a positioner are available.

Q: How can the robot be mounted?
A: The ARC Mate 100iD supports floor, upside-down and angle mounting, so it fits a wide range of welding workstation layouts. Angle mount is not supported on the 4-brake type.

For fabricators building a productive welding workstation, the FANUC ARC Mate 100iD combines a 10 kg payload, a 1,441 mm reach and ±0.02 mm repeatability with a fully cable-integrated, slim-arm design. Integrated torch and sensor cable routing, high rigidity and ROBOGUIDE offline teaching make it a practical welding robot for steel and aluminum work, while +RVision and positioner coordinated motion extend its reach into complex joints. Share your part mix and joint access, and we will confirm the right configuration and torch package.