Hefei Purple Horn E-Commerce Co., Ltd.
| Description | SPM-AA-C26 Power Driver Modules RoHS |
| Mfr. Part # | FNA41560B2 |
| Package | SPM-AA-C26 |
| Model Number | FNA41560B2 |
View Detail Information
Explore similar products
3 phase inverter module AOS AIP5D05K060Q4S with integrated HVIC drivers and
IPM Module AOS AIP5D15K060Q4 with Trench Shielded Planar Gate IGBT and Multiple
600 volt 10 amp 3 phase inverter module AOS AIP3D10A060Q6N for compressors
motor drive module AOS AIP3D05A060Q4N featuring 600 volt 5 amp trench shielded
Product Specification
| Description | SPM-AA-C26 Power Driver Modules RoHS | Mfr. Part # | FNA41560B2 |
| Package | SPM-AA-C26 | Model Number | FNA41560B2 |
The FNA41560 / FNA41560B2 is a Motion SPM 45 module, offering a comprehensive high-performance inverter output platform for AC induction, Brushless DC, and PMSM motors. These modules are optimized to minimize EMI and energy loss by integrating gate drivers with the internal IGBTs. They provide multiple protection features including undervoltage lockout, overcurrent protection, thermal monitoring, and fault reporting. A high-speed HVIC chip requires only a single power supply and converts logic-level gate input signals into high-voltage, high-current drive signals for the internal IGBTs. Separate IGBT negative terminals are available for each phase, supporting a wide range of control algorithms.
| Device | Description | Package | Package Type | Quantity | Voltage Rating | Current Rating | Switching Frequency |
| FNA41560 | Motion SPM 45 Module | SPMAA-A26 | Rail | 12 | 600 V | 15 A | Optimized for 5 kHz |
| FNA41560B2 | Motion SPM 45 Module | SPMAA-C26 | Rail | 12 | 600 V | 15 A | Optimized for 5 kHz |
| Parameter | Symbol | Condition | Min | Typical | Max | Unit |
| Inverter Section | ||||||
| Power Supply Voltage | VPN | Applied between P - NU, NV, NW | 450 | V | ||
| Power Supply Voltage (Surge) | VPN (Surge) | Applied between P - NU, NV, NW | 500 | V | ||
| Collector-Emitter Voltage | VCES | 600 | V | |||
| Collector Current (Single IGBT) | IC | TC = 25C, TJ < 150C | 15 | A | ||
| Collector Current (Peak, Single IGBT) | ICP | TC = 25C, TJ < 150C, pulse width < 1 ms | 30 | A | ||
| Collector Power Dissipation | PC | TC = 25C, per die | 41 | W | ||
| Junction Temperature | TJ | -40 | 150 | C | ||
| Control Section | ||||||
| Control Supply Voltage | VCC | Applied between VCC(H), VCC(L) - COM | 20 | V | ||
| High-Side Control Supply Voltage | VBS | Applied between VB(U) - VS(U), VB(V) - VS(V), VB(W) - VS(W) | 20 | V | ||
| Input Signal Voltage | VIN | Applied between IN(UH), IN(VH), IN(WH), IN(UL), IN(VL), IN(WL) - COM | -0.3 | VCC + 0.3 | V | |
| Fault Output Supply Voltage | VFO | Applied between VFO - COM | -0.3 | VCC + 0.3 | V | |
| Fault Output Current | IFO | Sink current at VFO pin | 1 | mA | ||
| Current Sense Input Voltage | VSC | Applied between CSC - COM | -0.3 | VCC + 0.3 | V | |
| Bootstrap Diode Section | ||||||
| Maximum Repetitive Reverse Voltage | VRRM | 600 | V | |||
| Forward Current | IF | TC = 25C, TJ < 150C | 0.50 | A | ||
| Forward Current (Peak) | IFP | TC = 25C, TJ < 150C, pulse width < 1 ms | 1.50 | A | ||
| Junction Temperature | TJ | -40 | 150 | C | ||
| Entire System | ||||||
| Self-Protection Supply Voltage Limit (Short Circuit Capability) | VPN(PROT) | VCC = VBS = 13.5 ~ 16.5 V, TJ = 150C, non-repetitive, < 2 s | 400 | V | ||
| Storage Temperature | TSTG | -40 | 125 | C | ||
| Insulation Voltage | VISO | 60 Hz, sinusoidal, AC 1 minute, ceramic substrate to pin | 2000 | Vrms | ||
| Parameter | Symbol | Condition | Min | Typical | Max | Unit |
| Thermal Resistance | ||||||
| Junction-to-Case Thermal Resistance | Rth(j-c)Q | Inverter IGBT part (per 1/6 module) | 3.0 | C/W | ||
| Junction-to-Case Thermal Resistance | Rth(j-c)F | Inverter FWD part (per 1/6 module) | 4.3 | C/W | ||
| Electrical Characteristics (TJ = 25C, unless otherwise specified) | ||||||
| Inverter Section | ||||||
| Collector-Emitter Saturation Voltage | VCE(SAT) | VCC = VBS = 15 V, VIN = 5 V, IC = 15 A, TJ = 25C | 1.8 | 2.3 | V | |
| FWD Forward Voltage | VF | VIN = 0 V, IF = 15 A, TJ = 25C | 1.8 | 2.3 | V | |
| Switching Time (Turn-ON) | tON | VPN = 300 V, VCC = VBS = 15 V, IC = 15 A, TJ = 25C, Inductive Load (Note 3) | 0.45 | 1.25 | s | |
| Switching Time (Turn-ON, Internal Gate Drive) | tC(ON) | 0.25 | 0.50 | s | ||
| Switching Time (Turn-OFF) | tOFF | 0.75 | 1.25 | s | ||
| Switching Time (Turn-OFF, Internal Gate Drive) | tC(OFF) | 0.25 | 0.50 | s | ||
| Reverse Recovery Time | trr | 0.15 | s | |||
| Collector-Emitter Leakage Current | ICES | VCE = VCES | 1 | mA | ||
| Control Section | ||||||
| Static Supply Current (High-Side) | IQCCH | VCC(H) = 15 V, IN(UH,VH,WH) = 0 V | 0.10 | mA | ||
| Static Supply Current (Low-Side) | IQCCL | VCC(L) = 15 V, IN(UL,VL, WL) = 0 V | 2.65 | mA | ||
| Supply Current (High-Side) | IPCCH | VCC(L) = 15 V, fPWM = 20 kHz, Duty Cycle = 50%, one PWM signal applied to high-side | 0.15 | mA | ||
| Supply Current (Low-Side) | IPCCL | VCC(L) = 15 V, fPWM = 20 kHz, Duty Cycle = 50%, one PWM signal applied to low-side | 3.65 | mA | ||
| Static Supply Current | IQBS | VBS = 15 V, IN(UH, VH, WH) = 0 V | mA | |||
Company Details
Business Type:
Manufacturer,Distributor/Wholesaler,Agent,Importer
Year Established:
2009
Employee Number:
300~500
Ecer Certification：
Verified Supplier
.gtr-container-a1b2c3d4 { font-family: Verdana, Helvetica, "Times New Roman", Arial, sans-serif; color: #333; padding: 20px; line-height: 1.6; font-size: 14px; box-sizing: border-box; } .gtr-container-a1b2c3d4 .gtr-heading { font-size: 18px; font-weight: bold; c... .gtr-container-a1b2c3d4 { font-family: Verdana, Helvetica, "Times New Roman", Arial, sans-serif; color: #333; padding: 20px; line-height: 1.6; font-size: 14px; box-sizing: border-box; } .gtr-container-a1b2c3d4 .gtr-heading { font-size: 18px; font-weight: bold; c...
Get in touch with us
Leave a Message, we will call you back quickly!