IPM Module AOS AIP5D15K060Q4 with Trench Shielded Planar Gate IGBT and Multiple

Product Specification

AIP5D15K060Q4 / AIP5D15K060Q4S Intelligent Power Module

Product Overview

The AIP5D15K060Q4 / AIP5D15K060Q4S is a Dual-In-Line Package Intelligent Power Module (IPM) designed for 3-phase inverter applications. It features a Trench Shielded Planar Gate IGBT with integrated HVIC drivers, offering robust protection mechanisms including control supply under-voltage lockout (UVLO), over-temperature (OT) protection, temperature monitoring (VOT), and short-circuit current protection (CSC). The module boasts a wide input interface (3-18V) with Schmitt trigger receiver circuits and isolation ratings of 2000Vrms. It is ideal for AC 100-240Vrms class low power motor drives found in washing machines, compressors, fan motors, cleaners, and air conditioners.

Product Attributes

• Brand: AOS (Alpha and Omega Semiconductor)
• Certifications: UL Recognized (UL1557 File E345245)
• Compliance: RoHS compliant, AOS Green Products (reduced levels of Halogens)
• Package Type: Dual-In-Line Package (IPM-5 / IPM-5A)

Technical Specifications

Key Features

• 600V-15A (Trench Shielded Planar Gate IGBT)
• 3 phase Inverter module including HVIC drivers
• Built-in bootstrap diodes with integrated current-limiting resistor
• Control supply under-voltage lockout protection (UVLO)
• Over-temperature (OT) protection and temperature monitoring (VOT)
• Short-circuit current protection (CSC)
• Controllable fault out signal (VCF)
• Wide input interface (3-18V), Schmitt trigger receiver circuit (Active High)

Applications

• AC 100-240Vrms class low power motor drives
• Washing machines
• Compressors
• Fan Motors
• Cleaners
• Air-conditioners

Pin Configuration

Refer to the provided diagrams for detailed pin configuration.

Absolute Maximum Ratings

Thermal Resistance

Electrical Characteristics

Recommended Operation Conditions

Mechanical Characteristics

Notes on Protection Functions

• Short-Circuit Protection (SC): Works only for low sides with an external shunt resistor and RC filter.
• Over-Temperature Protection (OT): When LVIC temperature exceeds the trip level (OTT), OT protection is triggered and fault outputs. The IPM does not automatically shut down IGBTs; the controller (MCU) should stop the IPM.
• Fault Output (VCF): Controllable fault out signal corresponding to SC, UV, and OT faults. Pulse width can be fixed (min 20s) or controlled.
• Temperature Monitoring (VOT): Can be used simultaneously with OT protection or independently with a 10k resistor connection.

Application Circuit Notes

• Bootstrap diodes' negative electrodes should be connected directly to U, V, W pins.
• Shunt resistor wiring should be short to prevent SC level fluctuation.
• Ground wiring should be short to prevent noise interference.
• Control and power grounds should be connected at a single point (N1).
• It is recommended to use only the (15) COM pin for common supply ground.
• Zener diodes are recommended between control supply pins for surge protection.
• Bus capacitors should be placed close to P and N1 terminals.
• RC filter components for CSC and VOT should be tight tolerance and temperature-compensated.
• Input drives are active-high with a minimum 3.5k pull-down resistor.
• VCF output is open drain and requires a pull-up resistor.
• Direct drive from MCU is possible without opto-coupler or isolation transformer.
• Line ripple voltage should be limited (dV/dt 1V/s, Vripple 2Vp-p).

Package Dimensions

Refer to Figures for IPM-5 and IPM-5A package dimensions.