Transportation Simulation Vibration Table Electromagnetic Shaking Table Test

Product Specification

Transportation Simulation Vibration Table Electromagnetic Shaking Table Test Machine

 
Product Overview
 

Simulation transport vibration table, also known as "vibration table", simulate the damage caused by the turbulence of the product during automobile transportation, to identify whether the product is able to withstand environmental vibration, suitable for electronic, mechanical and electrical, optoelectronics, motor vehicles, toys and other industries of research, development, quality control, manufacturing. It is a rare testing machine for you to improve product quality and reliability.

The simulation transportation vibration test bench is suitable for vibration test of toys, electronics, furniture, gifts, ceramics, communications, equipment, computers and auto parts, etc., to inspect its transportation effect or durability uniformity.

This machine according to the European and American similar equipment restructuring, rotary vibration, in line with the European and American transportation standards, in line with EN71 ANSI, UL, ASTM, ISTA and other test standards.

Test purpose

This machine is a series of controlled vibration simulation in the experiment to test whether the product can withstand the test of transport or vibration environmental factors in the life cycle, and can also determine the requirements of product design and function standards. According to statistics, improving the design level by 3% will increase recycling by 20% and reduce unnecessary expenses by 18%.

1. Strength of structure.

2. Loosening of the bond.

3. Protect the wear and tear of materials.

4. Damage of components.

5. Poor contact of electronic components.

6. Circuit short circuit and intermittent instability.

7. Deviation of the standard value of each piece.

8. The simulated transport shaking table will screen out the defective parts in advance.

9. Find the resonance relationship between parts, structure, packaging and transportation process, and improve its resonance factors.

The requirements of the simulated transportation vibration test bench are to confirm the reliability of the product and to screen out the defective products before leaving the factory in advance, and to evaluate the failure analysis of the defective products in order to become a high level and high trust product.

Main technical parameters

1. Maximum test load: 0-300kg

2. Frequency range: 100 ~ 300rpm

3. Amplitude range: 1 inch (25.4mm)

4. Vibration mode: rotary type (commonly known as horse type)

5. Simulated speed: 25 ~ 40km/h

6. Table size: 1100×1300mm

7. Guardrail: 1200mm

8. Control motor: AC variable frequency motor

9. Test bench dimensions: 1100×1380mm

10. Control box size: 370 × 350 × 910mm

11. Power supply voltage: AC220V 50Hz

12. Machine weight: about 550kg

Introduction to vibration testing

1. Place the test product on the vibration test platform with normal transportation. In order to prevent jumping off the table and maintain the direction, the vibration test platform can be surrounded by ropes;

2. The vibration frequency should be just enough to shake the goods off the table, and the metal sheet can be inserted between the sample and the table, and can walk in the longest edge gap of the sample (the thickness of the metal sheet is 1.5mm, the width is 50mm (optional));

Environmental requirement

1. On-site temperature: 5℃~+28℃(average temperature within 24 hours ≤28℃);

2. Relative humidity: ≤85%RH;

3. Power supply conditions: single-phase three-wire;

4. Voltage range: AC220V;

5. Frequency allowed fluctuation range: (50±0.5)Hz;

6. The grounding resistance of the PGND cable is less than 4 ohms.

7. The user is required to configure the air or power switch of the corresponding capacity for the device at the installation site, and the switch must be independent for the use of the device.