RJ45 Port Multi UTP POE Fiber Media Converter / POE Switch For Access Control

media converter / ST media converter / RJ 45

MC131012060

Product Introduction 

10/100M Fast Ethernet Media Converter, relies on its unique function ofoptical-electricity LFA (Link Failure Alert) to realize the extension of LAN Ethernet.

Ethernet Media Converter achieves the interconversionof 10/100Base-TX UTP Cable electrical signal with 100Base-FX optic cable. Itextends the network transmission range from 100m, the limit of copper Cable, to120Km on fiber. It adopts Store and Forward mode or Cut-Through mode to realizethe data transmission between network connection media of optical fiber andelectricity. It supports optical transmission under dual-fiber multi-mode,dual-fiber single mode and single fiber single mode.

MainFeatures:

Auto-Negotiation (802.3u) for10/100Base-TX for network upgrade.

Built in effective switching corefor flow control, reduce broadcast packet

Support Full/half duplexself-adaptive transmission mode and auto-negotiations

Support Automatically detecting andconfiguring the twisted pair port on the converter to the correct MDI or MDI-XConfiguration, convenient for system debug and installation

Support Link Failure Alert (LFA) ,Allows for quick diagnosis and resolution of network problems

Support full/half duplex operationfor each TP switched port

Support 10/100Mbps Store andForward mode or Cut-Through mode operation

Optical interface supports100Base-FX, and fixed 100Mbps full duplex operation

Support low delay transmission

Support 1600 bytes for Cut-Throughmode

Support 802.1Q VLAN tagged packetstransmission

Support QoS, ensure VOIP datapackage transmission

Ultra low power dissipation(<2W),  low heat generation , enabledsteady operation over a long time

Support the port choice ofdual-fiber multi-mode,  dual-fiber singlemode and single fiber single mode, which expands the customers requirements

Technical indicators:

Parameters     Specification

Access mode   10/100Mbps

Standard  IEEE802.3 10Base-TEthernet,IEEE802.3u,100Base-TX/FX Fast Ethernet, IEEE802.3x Flow control

Wavelength     850nm/1310nm/1550nm

Transmissionrange Dual-fiber multi-mode :2Km, 

Dual-fibersingle mode :20/40/60/80/100/120Km, 

singlefiber single mode :20/40/60/80/100Km

CAT 5 UTPcable:100m

FX and TXPorts    1 RJ45 connector: connect STP/UTPCAT 5 twisted pair

1 opticalinterface:  multi-modeSC or ST opticalinterface (fiber size 50,62.5/125μm)

Single modeST/FC optical interface (fiber size 9/125μm)

Singlefiber single mode ST/FC optical interface (fiber size 9/125μm)

Conversionmode   Store and Forward mode orCut-Through mode

Buffer size      Built in 128Kb RAM for data buffer

Flowcontrol   Full duplex: flow control,half-duplex

Bit errorrate:  <10-9

MTBF     100 thousand hours.

LEDindicator lamp       POWER(power supply),FX LINK/ACT(optical fiber connected/action)

FDX(FX fullduplex ), TX LINK/ACT(twisted pair connected/action)

TX 100(twisted pair 100M transmission rate), FX 100(optical fiber 100M transmissionrate)

POWER  Power adapter: input: AC 90~264V /DC100~380V   output:DC5V 1A

powerconsumption       <2W

Operatingtemperature   -10~55

Workinghumidity  5%~90%

Storagetemperature       -40~70

Storagetemperature       5%~90% no condensation

Dimensions:    Outside power supply:94mmX71mmX26mm