3619A01-030A1 ATS Temperature Sensor, Spare Part for New Energy Bus and Public

Product Specification

Purpose

This ATS temperature sensor is a professional spare part specially used for new energy buses and urban public buses. It is responsible for collecting real-time temperature data of the ATS system, and transmits the collected temperature signals to the whole vehicle controller. The controller judges the operating state of the thermal management system according to the temperature data, so as to realize intelligent temperature monitoring, heat dissipation control and whole vehicle thermal management, avoid abnormal high temperature of the system, and ensure the safe and stable operation of the bus.

Product Features

  1. Equipped with brass sensing head and metal sensing probe, featuring fast temperature response and high detection precision.

  2. Adopt integrated wiring harness structure, matched with black flame-retardant corrugated protective conduit to prevent wire abrasion and aging.

  3. Fitted with special waterproof connector, reaching IP65 protection grade, suitable for complex working environments of buses.

  4. Threaded screw-in structure for installation, with good sealing performance after assembly.

  5. Made of high temperature resistant materials, capable of long-term stable work in the operating environment of vehicle thermal management system.

Product Advantages

  1. High compatibility: It can be used as replacement spare part for new energy buses and urban public buses, with the part number 3619A01-030A1.

  2. Long service life: Wear-resistant, anti-corrosion and anti-aging design, adapt to bumpy road conditions and variable outdoor temperature.

  3. Stable signal transmission: Effectively reduce signal interference, ensure accurate and continuous feedback of temperature data.

  4. Convenient maintenance: Simple disassembly and assembly, which can greatly shorten the vehicle maintenance time.

  5. Reliable packaging: Neutral independent carton packaging with shockproof foam inside, effectively protecting the product during long-distance transportation.

Installation Steps

  1. Cut off the power supply of the whole vehicle, wait until the ATS system is fully cooled down, and confirm there is no residual high temperature on the installation position.

  2. Remove the old temperature sensor from the threaded mounting hole, clean impurities, dirt and residual sealing material inside the mounting hole.

  3. Align the threaded part of the new ATS temperature sensor with the mounting hole, screw it in manually first, and then use a suitable tool to tighten it properly. Do not use excessive force to prevent thread slipping or shell damage.

  4. Connect the waterproof connector of the sensor to the vehicle matching plug, and press the connector tightly to ensure it is fully locked without looseness.

  5. Arrange the wiring harness reasonably, fix the corrugated conduit to avoid friction with hard parts or high-temperature components of the vehicle.

  6. Switch on the vehicle power supply, start the test, check whether the dashboard and controller can normally receive temperature signals, and confirm there is no leakage at the threaded installation position.

Notes

  1. Installation must be carried out after power off and cooling, operation with high temperature or live electricity will cause scald or circuit short circuit.

  2. It is forbidden to bend, cut or damage the sensor probe and wiring harness at will, which will lead to signal failure and product scrapping.

  3. Do not use excessive torque when tightening the thread, excessive force will damage the brass thread and affect the sealing effect.

  4. Check whether the connector is locked in place after wiring, loose plug will cause intermittent signal loss and system alarm.

  5. Prevent the product from being impacted and dropped before installation, collision may damage the internal sensing element.

  6. If the sensor fails to feed back temperature data normally after installation, check the connector, harness and mounting position in sequence, do not modify the internal structure of the sensor privately.

  7. The sensor is a precision electronic component, it should be stored in a dry environment, avoid long-term exposure to humid and corrosive gas environment.