Small Diameter Φ8-18mm Precision Tube Mill Machine ZY16 HF Welded Steel Pipe

Product Specification

Problem

Small diameter tube makers often struggle to hold roundness and weld straightness when running Φ8-18mm pipe. A tiny cross-section amplifies any roller misalignment into visible ovality and a wandering weld seam, so the finished tube fails dimensional checks even though the mill itself is running normally.

Cause

The root cause is cumulative forming error. With only 8-18mm outside diameter, a 0.05mm roller offset is a far larger relative deviation than on a 50mm pipe. When too few stands share the work, the strip edges are forced in one or two heavy passes, and that concentrated deformation shows up directly as out-of-round and off-center seams.

Solution

The ZY16 splits forming into a five-stand rough stage and a three-stand precision stage. Double-radius roller profiles guide the strip edges gradually, so the tube reaches the weld point already round and with a controlled edge gap. This staged load distribution keeps ovality low and the weld seam centered even at 90m/min, and the 42CrMo shafts hold that geometry over long runs.

Key Engineering Data

• Φ8-18mm OD range covers small precision, furniture and fluid tube sizes in one mill.
• Five rough plus three precision stands spread deformation to limit edge strain.
• Double-radius rollers guide edges gradually for lower ovality.
• 42CrMo shafts resist deflection to hold tolerance during high-speed runs.

Performance & Quality

In production trials, the staged forming plus double-radius rollers holds ovality within the tolerance small-diameter buyers demand. The 42CrMo shafts keep roll alignment stable across a full shift, so the Φ8-18mm tube holds roundness and weld straightness from the first meter to the last coil, cutting reject and rework on precision orders.

Application

The line is built for furniture, automotive fluid and structural tubing, handrails, fence posts and heat exchanger tubes where Φ8-18mm welded pipe must be dimensionally stable and weld-defect free.

Selection Guide

Select this configuration when your target pipe is Φ8-18mm and wall is 0.4-1.0mm. If you mainly run diameters above 18mm, choose the larger ZY20 mill instead; the ZY16 roller sets are optimized for the small range and are not efficient beyond it.

Application Scenarios

Round furniture tube with polished finish, small hydraulic and brake line tube, condenser and cooler pipe, and low-pressure structural tube for racks and frames.

FAQ

Q1. What OD range does the ZY16 cover?

The ZY16 covers Φ8-18mm outside diameter. Production outside this range requires a different roller set or a larger mill model such as the ZY20, because the forming rolls are profiled for the small diameter band.

Q2. How do you keep roundness stable on small tube?

We distribute forming across five rough and three precision stands with double-radius rollers, which keeps edge loading gradual and minimizes ovality instead of forcing the strip in fewer, heavier passes.

Q3. What strip width does Φ8-18mm pipe need?

Approximately 25-57mm depending on diameter and wall, so the mill accepts slitting coils in that width band. We confirm the exact width against your target OD and gauge.

Q4. Can one mill run the full 8-18mm range?

Yes, with the appropriate roller sets. The machine covers the range, but each specific size uses its own roller profile for the best roundness and weld quality.

Q5. How does the ZY16 compare on small tube tolerance?

It holds tight roundness and weld alignment because forming is split across eight stands, so small-diameter pipe runs within spec with far less rework than mills using fewer, heavier passes.

Q6. What tolerances can the ZY16 hold?

For Φ8-18mm tube the mill holds roundness and weld alignment within the tolerance precision buyers demand; exact values are set per size and material during commissioning.