Dune Wavy Rim Stemmed Cup 17.5 cm Tall 170 g Grey Green Glass

Dune Wavy Rim Stemmed Cup 17.5 cm Tall 170 g Grey Green Glass is a stemmed cup built around a straight body with a soft wavy rim on a bulb stem over a 7 cm foot in pale grey green, translucent, with smooth body with a wavy rim and swollen stem. It is produced in our glass workshop for buyers who need a repeatable decorative programme rather than a one off sample, and the piece shown here carries the a narrow straight cup with a soft wavy rim, on a swollen stem.

Wavy rims are the least protected part in transit, so divider spec should be confirmed alongside the sample. Every unit is annealed in a controlled lehr so that wall stress stays within our breakage specification, and dimensions are checked against the measurement sheet printed on the photography. The result is a glass that looks individual on the shelf but behaves predictably in a container load.

• Wavy Rim: The soft wavy edge is the identifying detail and the first thing a buyer notices.
• Narrow 5 cm Body: A slim body suits water, liqueurs and dessert serves.
• Bulb Stem: The swollen stem sits comfortably between the fingers.
• Grey Green Tone: A muted colour that suits stone and neutral table settings.
• 170 g Weight: Light enough for volume service, with the mass in the foot.
• Batch Colour: Tone comes from the batch, so it holds across reorders.

This stemmed cup is aimed at water and cocktail service, hotel rooms and gift retail. Buyers typically place it in a range that needs one recognisable decorative accent without moving to a full bespoke mould, and because the body is a standard production shape the tooling cost is already absorbed into the piece price.

In service the glass is expected to move between back of house washing and front of house display several times a day. The surface withstands standard commercial detergents, and the rim geometry has been kept simple so that stacking and racking do not put point loads on the lip. For retail programmes the same item can be boxed as a single unit or combined with the matching pieces in our range to build a story around colour and pattern.

Sampling buyers usually test three things: whether the decoration survives twenty dishwasher cycles, whether the base sits flat on a granite or marble surface, and whether case pack dimensions match their pallet plan. All three can be confirmed with a stock sample before any production deposit is placed.

Each piece is packed in a moulded pulp or corrugated divider inside a five layer export carton, with a printed sleeve available for retail programmes. Case pack quantities are set so that a full pallet loads without void fill, which keeps freight cost per unit down for mixed container orders.

Production is inspected at three points: incoming glass quality, decoration placement, and final packing. AQL inspection follows the usual 2.5 major and 4.0 minor plan unless a buyer specifies otherwise, and we keep a retained sample from each run so that repeat orders can be matched for colour and pattern density.

• Wavy Rim Glass Cup
• Grey Green Stemware
• Bulb Stem Cup

Hand washing with a soft sponge is recommended where a decorative surface is present, and dishwasher use is acceptable on a normal cycle at moderate temperature. Avoid sudden temperature change such as pouring boiling liquid into a chilled glass, since thermal shock remains the most common cause of breakage in any annealed glassware. Stored correctly, the piece is designed for years of daily use.