Blush Ribbed Stemmed Glass Vase 20 cm Tall 310 g Pink Pedestal Flower Holder

Blush Ribbed Stemmed Glass Vase 20 cm Tall 310 g Pink Pedestal Flower Holder is a stemmed glass vase built around a straight cylindrical cup on a pinched neck over a flared pedestal foot in blush pink, translucent, with vertical ribbing on the body and foot, smooth rim. It is produced in our glass workshop for buyers who need a repeatable decorative programme rather than a one off sample, and the piece shown here carries the a stemmed pedestal form borrowed from stemware, sized for a single stem or a small bunch.

Stemmed vases are usually packed with the foot supported separately; buyers shipping by courier should confirm the inner divider spec before ordering. Every unit is annealed in a controlled lehr so that wall stress stays within our breakage specification, and dimensions are checked against the measurement sheet printed on the photography. The result is a glass that looks individual on the shelf but behaves predictably in a container load.

• Pedestal Form: The pinched neck and flared foot lift the body, which gives a single stem more presence than a plain cylinder.
• Blush Body: A soft pink tone that reads warm under tungsten light and neutral in daylight.
• Ribbed Surface: Ribs run the full height of the body, so the colour deepens where the wall curves.
• 310 g Build: A weighted foot keeps the vase upright with a top heavy arrangement.
• 5.5 cm Opening: Narrow enough to hold stems upright without a frog or grid.
• Retail Ready: The silhouette photographs well as a single unit, which suits gift and homeware listings.

This stemmed glass vase is aimed at florists, hotel room dressing, wedding table styling and home decor retail. Buyers typically place it in a range that needs one recognisable decorative accent without moving to a full bespoke mould, and because the body is a standard production shape the tooling cost is already absorbed into the piece price.

In service the glass is expected to move between back of house washing and front of house display several times a day. The surface withstands standard commercial detergents, and the rim geometry has been kept simple so that stacking and racking do not put point loads on the lip. For retail programmes the same item can be boxed as a single unit or combined with the matching pieces in our range to build a story around colour and pattern.

Sampling buyers usually test three things: whether the decoration survives twenty dishwasher cycles, whether the base sits flat on a granite or marble surface, and whether case pack dimensions match their pallet plan. All three can be confirmed with a stock sample before any production deposit is placed.

Each piece is packed in a moulded pulp or corrugated divider inside a five layer export carton, with a printed sleeve available for retail programmes. Case pack quantities are set so that a full pallet loads without void fill, which keeps freight cost per unit down for mixed container orders.

Production is inspected at three points: incoming glass quality, decoration placement, and final packing. AQL inspection follows the usual 2.5 major and 4.0 minor plan unless a buyer specifies otherwise, and we keep a retained sample from each run so that repeat orders can be matched for colour and pattern density.

• Blush Stemmed Glass Vase
• Ribbed Pedestal Vase
• Pink Flower Holder

Hand washing with a soft sponge is recommended where a decorative surface is present, and dishwasher use is acceptable on a normal cycle at moderate temperature. Avoid sudden temperature change such as pouring boiling liquid into a chilled glass, since thermal shock remains the most common cause of breakage in any annealed glassware. Stored correctly, the piece is designed for years of daily use.