Squat Clear Glass Pitcher Rainbow Handle 12 cm Rim 11.5 cm Tall 740 g Jug

Squat Clear Glass Pitcher Rainbow Handle 12 cm Rim 11.5 cm Tall 740 g Jug is a glass pitcher built around a low rounded body with a full rainbow twisted handle and wide lip in clear body with a multicolour twisted handle, with plain wall with a rainbow swirl handle. It is produced in our glass workshop for buyers who need a repeatable decorative programme rather than a one off sample, and the piece shown here carries the a low wide body set against a rainbow twisted handle, made for table presence rather than volume.

Coloured handles are joined from separate gathers before forming, so colour bleed at the joint should be accepted within a tolerance. Every unit is annealed in a controlled lehr so that wall stress stays within our breakage specification, and dimensions are checked against the measurement sheet printed on the photography. The result is a glass that looks individual on the shelf but behaves predictably in a container load.

• Rainbow Handle: The twisted colour handle is the whole design, so the body stays plain and clean.
• Squat Profile: A low wide body sits under cabinet shelves and looks generous on the table.
• 740 g Build: Heavy enough to feel solid when full and poured one handed.
• Wide Lip: A broad mouth pours cleanly without a separate spout.
• Clear Body: Water and juice levels remain visible during service.
• Retail Appeal: The colour handle photographs strongly for catalogue and marketplace listings.

This glass pitcher is aimed at cafes, restaurants, hotel breakfast service and design led retail. Buyers typically place it in a range that needs one recognisable decorative accent without moving to a full bespoke mould, and because the body is a standard production shape the tooling cost is already absorbed into the piece price.

In service the glass is expected to move between back of house washing and front of house display several times a day. The surface withstands standard commercial detergents, and the rim geometry has been kept simple so that stacking and racking do not put point loads on the lip. For retail programmes the same item can be boxed as a single unit or combined with the matching pieces in our range to build a story around colour and pattern.

Sampling buyers usually test three things: whether the decoration survives twenty dishwasher cycles, whether the base sits flat on a granite or marble surface, and whether case pack dimensions match their pallet plan. All three can be confirmed with a stock sample before any production deposit is placed.

Each piece is packed in a moulded pulp or corrugated divider inside a five layer export carton, with a printed sleeve available for retail programmes. Case pack quantities are set so that a full pallet loads without void fill, which keeps freight cost per unit down for mixed container orders.

Production is inspected at three points: incoming glass quality, decoration placement, and final packing. AQL inspection follows the usual 2.5 major and 4.0 minor plan unless a buyer specifies otherwise, and we keep a retained sample from each run so that repeat orders can be matched for colour and pattern density.

• Squat Rainbow Pitcher
• Coloured Handle Jug
• Short Glass Pitcher

Hand washing with a soft sponge is recommended where a decorative surface is present, and dishwasher use is acceptable on a normal cycle at moderate temperature. Avoid sudden temperature change such as pouring boiling liquid into a chilled glass, since thermal shock remains the most common cause of breakage in any annealed glassware. Stored correctly, the piece is designed for years of daily use.