Cutting tools surface auto control motor drive drying and cleaning machine

Product Specification

Cutting tools surface auto control motor drive drying and cleaning machine

Product introduction

1. The machine can realize demagnetization → cleaning → drying → oiling, which can be completed at one time.

2. Conveying part: adopt crawler type conveying and use three independent frequency conversion motors to drive.

3. Cleaning part: heating the water and cleaning the workpiece with circulating filtered water to achieve the best cleaning effect.

4. Drying part: the drying oven is used to dry the workpiece in strong wind to ensure that there is no moisture in the workpiece, which is

convenient for oil passing in the next step.

5. Oiling part: the oil cotton is used to extrude the excessive oil on the workpiece to make the oil film on the surface of the workpiece even.

6. Demagnetization, cleaning and oiling can be used separately. It is equipped with movable caster, which is easy to use.

Saw blade cleaning Dryer

Product description

1. The cleaning part is cleaned with a high-temperature wire rolling brush, which can thoroughly clean the oil, wax and stains on the workpiece.

2. The drying part adopts imported special absorbent cotton to absorb water, dry with high pressure and strong hot air, and clean and dry in one step.

3. The material speed is adjustable by frequency conversion, which can automatically clean workpieces with a thickness of less than 6MM, and has strong applicability.

4. The three-section stainless steel water tank is used for circulating cleaning, and the water temperature can be as high as 100 ℃, so that the cleaning effect is the best.

5. The machine is equipped with movable casters, which is convenient for application.

Roller type flat metal cleaning machine

Product description

1. The feeding and discharging of the cleaning machine are driven by stainless steel rollers or rubber rollers, which can continuously and automatically feed.

2. It is suitable for cleaning relatively large saw blades, and aluminum alloy plates or coils.

3. The upper and lower drying is adopted, so that the steel plate is completely free of moisture.

4. Air knives can be installed at the discharge point according to customer requirements.

5. The machine is equipped with movable casters, which is easy to use.

Chain Type Ultrasonic Cleaner

Product description

This machine is suitable for batch automatic cleaning of various stainless steel stamping products, hardware tools, metal saw blades, plumbing hardware, door lock hardware, machinery parts, auto parts, medical equipment and other products. It has the advantages of wide application range, good cleaning effect, high efficiency, easy operation, safety and reliability, environmental protection and high efficiency, etc. It is an ideal product for efficient production of modern enterprises.

1. The fuselage frame, water tank and sealing plate are made of stainless steel and have a long service life.

2. The transmission part adopts a special chain net conveying and circulating structure, and the cleaning speed is adjustable.

3. The cleaning part consists of a top-shock ultrasonic vibration plate, a cleaning tank and a heating system. The cleaning length can be customized according to product requirements.

4. The discharge part is equipped with a circulating filter spray washing system, which can effectively reduce pollution. After washing, a high-pressure air knife device can be installed according to product requirements.

5. After the material is discharged, it can be connected to the brush cleaning machine for fine cleaning again.

6. It can be combined with different solvents to achieve different effects and meet different production processes: such as oil removal, rust removal, oxide removal, wax removal, chip removal or phosphating, passivation, electroplating, etc.