3.8mm DX51D Hot Dipped Galvanized Steel Coil with 40–450g/m² Zinc Coating for

Product Specification

3.8mm DX51D Hot Dipped Galvanized Steel Coil with 40–450g/m² Zinc Coating for Construction and Industrial Sheet Processing

1.Product Overview

Hot dipped galvanized steel coil in the 0.09–3.8 mm range is used in construction panels, enclosure parts, appliance components, and general sheet fabrication where zinc-based corrosion protection and stable downstream processing are required. For thicker gauges close to 3.8 mm, the material is often selected when panel rigidity and dimensional stability are more important than lightweight design.

DX51D and equivalent commercial grades are commonly used in roll forming, cut-to-length production, bending, and panel fabrication. The zinc layer helps protect the steel surface during storage, transport, and service, especially in indoor humid conditions or semi-exposed applications.

2.Technical Solution

Product performance is based on:

• Continuous hot dip galvanizing with controlled zinc coating mass
• Zinc layer providing barrier protection and sacrificial protection
• Wide gauge range covering light sheet to thicker industrial panel use
• Multiple hardness options for different forming and rigidity requirements
• Standard coil dimensions for slitting, decoiling, and cut-to-length processing

In practical production, zinc coating level affects corrosion resistance, while thickness, hardness, and mechanical properties influence bending performance, shape retention, and structural stability. For thicker galvanized coil, higher stiffness can support heavier-duty sheet applications and more rigid fabricated parts.

3.Specifications

4.Application

• Roofing sheets and roof accessories
• Wall cladding and modular building panels
• Electrical cabinets and industrial enclosures
• Appliance panels and structural sheet parts
• Automotive peripheral components
• General cut-to-length and slit-strip fabrication

5.Processing

• Cut-to-length sheet production
• Slitting into narrower strips
• Roll forming for panel and profile sections
• Bending and folding
• Stamping and punching
• Surface painting or secondary coating when required

6.Advantages

• 0.09–3.8 mm range supports both light-gauge and thicker industrial sheet use
• 40–450 g/m² coating range covers general indoor to more exposed environments
• Multiple hardness levels allow selection by forming route and rigidity requirement
• Standard coil sizes fit common decoiling, slitting, and cut-to-length equipment
• Different spangle options support visible finish and downstream coating requirements
• Coil format improves productivity in continuous fabrication lines

7.How to Choose

• Thicker panel or more rigid fabricated part → choose 2.0–3.8 mm range
• General bending and panel forming → soft or medium hard is commonly selected
• Profile sections requiring stronger shape retention → full hard may be considered
• Outdoor or humid service environment → higher zinc coating is usually preferred
• Visible galvanized finish → choose spangle according to appearance requirement

8.FAQ

Q1: Is thicker galvanized coil suitable for industrial panel fabrication?
Yes, thicker gauges are commonly used where better rigidity and dimensional stability are required in fabricated sheet parts.

Q2: What is the difference between soft, medium hard, and full hard?
The difference mainly affects forming behavior and rigidity. Softer material is easier to bend, while harder material generally provides better shape retention after forming.

Q3: Can this coil be supplied as sheets or slit strips?
Yes, it can be cut to length into sheets or slit into narrower strips according to downstream production requirements.

Q4: Which coating level is commonly selected for more exposed environments?
Higher zinc coating levels are generally selected when stronger corrosion resistance is required in humid or outdoor service conditions.

Q5: Is DX51D suitable for roofing and general sheet processing?
Yes, DX51D is widely used for roofing, cladding, appliance panels, and general fabricated galvanized sheet applications.